IP PortfolioInterface PHYsethernet_phy
of_eth_phy_10gbase_t
10GBASE-T Ethernet PHY
Maturity plannedTargets ASIC (CMOS) onlyDifficulty Very hardPriority 3
10 Gbit/s copper PHY with DSQ128 modulation, LDPC decoding, Tomlinson-Harashima precoding, multi-rate fallback and XFI/USXGMII interface.
Planned. This block is specified in the catalog with its interfaces and targets. No implementation exists yet; the skeleton command below generates a lint-clean shell with its ports and registers.
Interfaces
| Port | Direction | Kind | Width | Notes |
|---|---|---|---|---|
| ctrl | in/out | APB control bus | 32 | Control and status registers, including ID, VERSION and STATUS |
| mdi | inout | analog | 8 | |
| mac_tx | in | parallel | 64 | |
| mac_rx | out | parallel | 64 | |
| mdc | in | clock | 1 | |
| mdio | inout | serial | 1 | |
| refclk | in | clock | 1 |
Standards
- IEEE 802.3an-2006
More in ethernet_phy
| ID | Block | Maturity |
|---|---|---|
| of_eth_phy_100base_tx | 10/100BASE-TX Ethernet PHY | planned |
| of_eth_phy_1000base_t | 10/100/1000BASE-T Ethernet PHY | planned |
| of_eth_phy_nbase_t | 2.5G/5GBASE-T Ethernet PHY | planned |
| of_eth_phy_100base_t1 | 100BASE-T1 automotive Ethernet PHY | planned |
| of_eth_phy_1000base_t1 | 1000BASE-T1 automotive Ethernet PHY | planned |
| of_eth_phy_mgig_t1 | 2.5G/5G/10GBASE-T1 automotive PHY | planned |
| of_eth_phy_10base_t1s | 10BASE-T1S multidrop PHY | planned |
| of_eth_phy_10base_t1l | 10BASE-T1L long-reach PHY | planned |
| of_eth_phy_10gbase_kr | 10GBASE-KR backplane PHY | planned |
| of_eth_gearbox_112g | 112G Ethernet retimer/gearbox | planned |